What length lug nuts for Draglites?

[CAPTAIN]

I bought a used set of Draglites and I'm wondering what shank length to buy that will be correct for a 15x8 and 15x3.5 Draglite?

Thanks!

[Weld 3]

The Draglite takes a 1.3 inch long lug with a 1.25 inch od concave washer. The washer is most important. Do not use a stamped small washer it will gouge the aluminum on the face of the wheel. What is you thread pitch I will give you the correct part number for the lug needed.
Thanks

[CAPTAIN]

It's for a Ford Mustang, 1/2" 20 I believe.

Thanks!

[Weld 3]

1/2 inch closed end lug part number us - 601-1416
1/2 inch open end lug nut part number is 601-1426
These come in packs of 4.
Thanks

[CAPTAIN]

Thanks for your help!

[DarwinBehne]

Greetings! Well I guess you can't argue with that huh?


_________________
buyiphonedotcom com/]buy iphone4 case

[Weld 3]

If you have questions regarding Weld Racing wheels, please post them up.
Thanks

[horsepowergod]

I am also in the same boat. I have new 35 spline axles with 1/2 x 20 x 3" screw in studs. I went and bought new 1/2 open lugs (part # 84088s, dont know if this is a weld part # or the companies, I was told they are weld lug nuts) Anyway I put my wheels on with just 2 lugs to get it on the ground to check wheel clearance. When I went to remove them one lug absolutely destroyed one of my studs. I used a tap to check the others and the qaulity was junk. Can you give me the correct part # to use with a draglite. The one I have now are 1/2x20x2"

Thanks

[Weld 3]

The part number for the 1/2 closed end lug is 601-1416 and the 1/2 inch open end lug is 601-1426. We do not make our own lug nuts. We spec the style and measurements from a lug nut mfg.
Hope this helps.
Thanks